Special Keynote Speaker
Dr. Tohru Yoshida
Processing technology research section Senior chief editor researcher, Steel research institute, Technical development headquarters, Nippon Steel & Sumitomo Metal Corporation
Dr. Hiroshi Ona
Emeritus professor, Takushoku University / Head, Flexible light-gauge-sections fabrication research institute
Overseas invitation speaker
Mr. Lander Arrupe
Product Manager, dataM Sheet Metal Solutions
Mr. Albert Forgas
Product Manager of Stampack, Quantech
Mr. Pyo Byung Gi
Person in charge of consulting section, VMTech
Case studies presentator
Mr. Norio Yasuda
Machine Works department, Machine Works First Division, Fuji Industrial Co.,Ltd.
9:30 Registration Open (★ with Simultaneous translation)
10:00-10:15 | Chairperson: Hiroyuki Nakamura (Dept. Manager Engineer Department)
Opening Remarks: Masaaki Miyake (ADA President & C.E.O) |
---|---|
10:15-11:00 | Special Keynote Speech Ⅰ
"Forming simulation technology for high strength steel sheet application to the automobile body"
Dr. Tohru Yoshida (Processing technology research section Senior chief editor researcher, Steel research institute, Technical development headquarters, Nippon Steel & Sumitomo Metal Corporation) |
11:00-11:35 | Guest Speech from Quantech Ⅰ ★
"The analysis example and the next version (V7.5.0) development project of the Stampack latest version"
Mr. Albert Forgas (Product Manager of Stampack, Quantech. ATZ) |
11:35-12:00 | Domestic User Case Speech
"Stampack practical use example"
Mr. Norio Yasuda (Machine Works department, Machine Works First Division, Fuji Industrial Co.,Ltd. ) |
12:00-13:00 | Lunch Break |
13:00-13:35 | Special Keynote Speech Ⅱ
"Fabrication of flexible lightweight shaped steel "
Dr. Hiroshi Ona (Emeritus professor, Takushoku University / Head, Flexible light-gauge-sections fabrication research institute) |
13:35-14:05 | Guest Speech from dataM Sheet Metal Solutions GmbH Ⅱ ★
"Latest Copra Roll Forming Design and Analysis Examples in Europe"
Mr. Lander Arrupe (Product Manager, dataM Sheet Metal Solutions) |
13:35-14:05 | User Case Speech
"The stress-analysis example of the roll forming simulation COPRA FEA RF"
Syunji Satoh (Group Leader, Engineering Group No.2, Design Analysis Consulting Dept., ADA) |
14:30-14:50 | Coffee Break |
14:50-15:20 | Guest Speech from dataM Sheet Metal Solutions GmbH Ⅲ ★
"Application of [flexible roll forming technology] (3D roll forming) to produce high strength auto parts"
Mr. Lander Arrupe (Product Manager, dataM Sheet Metal Solutions GmbH) |
15:35-16:00 | Guest Speech from CIMNE Ⅳ ★
"Research lines in the Oil and Gas fields at CIMNE"
Mr. Albert Forgas (Product Manager of Stampack, Quantech) |
16:00-16:40 | Guest Speech from VM Tech Ⅴ ★
"Introduction to MAPS-3D V9 and Examples"
My. ByungGi Pyo (person in charge of consulting section, VMTech) |
17:00-19:00 | Get-acquainted Party |